[TowerTalk] Two band inverted L

[Nick Pair]

A good source of spreader material is the local big box hardware or the local feed/farm store. They stock a fiberglass rod on various lengths and diameters as supports for electric fences. You can cut it to length with a hack saw, just be sure to seal ends with polyurethane spray paint. While you at it spray the whole thing and prevent the glass hairs that will develop over the years and make the rods a glove only situation. (those hairs hurt and are near impossible to find in flesh.) They also have high voltage clamps fro the rod to hold wire. Pretty cheap too. With the clamps and rod you can male just about any separation you need. They have end of run type insulators that are either ceramic eggs or polyethylene plastic that are great for center insulators or end insulators for any wire antenna application.
  As for wind wrapping, you could extend one of the lowest fiberglass spacers out to contact the tower and I think it would stop that for a <40 foot vertical. A simple black tywrap would be sufficient for tower end of the rod.
  For on or below ground radials you can see the effect of your new additions by how the impedance changes as you add the new ones. By adding 4 at a time and measuring after each addition you can catch the point where the diminishing returns hits your compromise level. With increased radial system you might have to adjust radiator length to recenter lowest SWR or highest gain to your favorite frequency.
  As always your mil age may vary.
   
  73
  Nick
  WB7PEK

 		
---------------------------------
Yahoo! Messenger with Voice. Make PC-to-Phone Calls to the US (and 30+ countries) for 2¢/min or less.