[TowerTalk] Rebar bending jig
Dan Kovatch
w8car at buckeye-express.com
Fri Jul 14 14:48:03 EDT 2006
When I did my foundation for my crankup the concrete company did the bending
to my specs, cut the straight pieces to length and delivered all to my
house. Some of the rebar was 1 inch in diameter-not something I wanted to
mess with even in a jig. All I had to do was wire it together. The cost was
very resonable and they did it a two days.
FYI
Dan
W8CAR
----- Original Message -----
From: "Freeman Pascal" <pascal at pascal.org>
To: <towertalk at contesting.com>
Sent: Friday, July 14, 2006 12:52 PM
Subject: [TowerTalk] Rebar bending jig
> I'm interested in any site or pictures for a bending jig for bending
> rebar. The jig should be able to handle 3/8 to 3/4" rebar.
>
> I would also be interested in any hints on how to do the bending. I
> suspect a 4ft pipe could be used as a bending arm if needed.
>
> If anyone can point me to any info I would be appreciative.
>
>
> -Freeman, N5FPP
>
>
>
> "If you are going through hell, keep going."
> -- Sir Winston Churchill
>
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
>
>
> __________________________________________________________
> Message transport security by GatewayDefender.com
> 12:53:28 PM ET - 7/14/2006
More information about the TowerTalk
mailing list