[TowerTalk] Phillystran vibration damping?

donovanf at starpower.net donovanf at starpower.net
Sun Jul 16 10:38:45 EDT 2006


Hi Dick,

I was very concerned that the vibration would damage my 
towers, so I took no chances.   The Preformed Line Products 
SVD dampeners completely solved the problem by installing 
one dampener at the top of each guy, within reach of the tower.

As the PLP literature describes, some cases may require more 
extreme measures involving multiple SVDs, but one per guy 
was adequate in my case.

73!
Frank
W3LPL

---- Original message ----
>Date: Sun, 16 Jul 2006 10:25:13 -0400
>From: "Dick Green WC1M" <wc1m at msn.com>  
>Subject: Re: [TowerTalk] Phillystran vibration damping?  
>To: <donovanf at starpower.net>, <towertalk at contesting.com>
>
>Frank,
>
>Can you provide some detail on your solution? How many 
dampers did you need
>and where on each guy were they placed? How did you 
determine these
>parameters? If they were placed out of reach from the ground 
or tower, did
>you have to disconnect each guy to install them?
>
>The product literature suggests vibration is potentially 
damaging to the
>connecting hardware. Is this a real concern for typical ham 
intallations, or
>is the primary issue the noise?
>
>Thank & 73,
>Dick WC1M
>
>> -----Original Message-----
>> From: donovanf at starpower.net 
[mailto:donovanf at starpower.net] 
>> Sent: Saturday, July 15, 2006 11:19 PM
>> To: towertalk at contesting.com
>> Subject: Re: [TowerTalk] Phillystran vibration damping?
>> 
>> Blake,
>> 
>> The product you're looking for is a Spiral Vibration 
>> Dampener, manufactured by Preformed Line Products.  
>> 
>> 
http://www.preformed.com/artsfest/files/literature/PLP_CommC
>> atSec23.pdf
>> 
>> I had the same problem on the guys on my 200 foot towers, 
>> and the SVD dampeners completely solved the problem.   
>> Philadelphia Rope Works, the manufacturer of Phillystran, 
was 
>> able to get them for me.
>> 
>> Good luck!   
>> 
>> 73
>> Frank
>> W3LPL
>> 
>> ---- Original message ----
>> >Date: Sat, 15 Jul 2006 21:30:13 -0400
>> >From: "Blake M." <n4gi at tampabay.rr.com>
>> >Subject: [TowerTalk] Phillystran vibration damping?  
>> >To: <towertalk at contesting.com>
>> >
>> >I thought there has been previous discussion on this?  I've 
not
>> been able to 
>> >get the right key words to get a match in the archives.....  
My
>> tower sounds 
>> >like a violin in during big winds and it's time to fix it.
>> >
>> >73,
>> >Blake N4GI
>> >
>> >
>> >
>> >---
>> >avast! Antivirus: Outbound message clean.
>> >Virus Database (VPS): 0628-5, 07/14/2006 Tested on: 
>> 7/15/2006 9:30:13 
>> >PM avast! - copyright (c) 2000-2006 ALWIL Software.
>> >http://www.avast.com
>> >
>> >
>> >
>> >_______________________________________________
>> >
>> >
>> >
>> >_______________________________________________
>> >TowerTalk mailing list
>> >TowerTalk at contesting.com
>> >http://lists.contesting.com/mailman/listinfo/towertalk
>> 
>> 
>_______________________________________________
>
>
>
>_______________________________________________
>TowerTalk mailing list
>TowerTalk at contesting.com
>http://lists.contesting.com/mailman/listinfo/towertalk


More information about the TowerTalk mailing list