[TowerTalk] Rotor Cable

Pete Smith n4zr at contesting.com
Fri Jun 23 10:56:31 EDT 2006


Cat 3 or 5 are great for relay control - I use CAT 3 for several devices over runs of more than 250 feet.  But the motor current demands of a rotator will probably produce excessive voltage drop.  

73, Pete N4ZR

At 09:56 AM 6/23/2006, Robert Pack (NX5M) wrote:
>I would discourage doing this.  I believe CAT5 is something like 24g.  I'd
>go with something like 18g for pins 1 and 2 and 20g for the rest.
>
>Bob
>
>----- Original Message -----
>From: "Dave Tipton" <dave at lodave.org>
>To: <towertalk at contesting.com>
>Sent: Friday, June 23, 2006 8:34 AM
>Subject: [TowerTalk] Rotor Cable
>
>
>> Ok, so I'm sure it's been asked before, but is there any real problem with
>using Category 5 cable to control a Ham IV?  This is going to be about a 100
>foot run (Thinking 90, but just being conservative).
>>
>>   I just happen to have scads of it laying around and thought it might be
>an inexpensive alternative.
>>
>>   Dave, W5DMT
>> _______________________________________________
>>
>>
>>
>> _______________________________________________
>> TowerTalk mailing list
>> TowerTalk at contesting.com
>> http://lists.contesting.com/mailman/listinfo/towertalk
>>
>>
>>
>
>
>_______________________________________________
>
>
>
>_______________________________________________
>TowerTalk mailing list
>TowerTalk at contesting.com
>http://lists.contesting.com/mailman/listinfo/towertalk 



More information about the TowerTalk mailing list