[TowerTalk] Tic ring feeline
David Robbins K1TTT
k1ttt at arrl.net
Mon Sep 11 17:01:56 EDT 2006
There are 2 ways I have used. The most common is to run the line up the
tower to the height of the boom brace struts, then loop it down and back up
to the strut and then down the strut to the beam. This of course assumes
you have a beam that needs the strut. Though in one case I couldn't do the
following method because of guy wires so I had to put a single strut up just
for the rotor loop.
The other way is to go down below the ring and leave a loop hang down and
bring it up to the outside of the boom cradle. This won't work if the ring
is too close above a guy wire as most of mine are.
David Robbins K1TTT
e-mail: mailto:k1ttt at arrl.net
web: http://www.k1ttt.net
AR-Cluster node: 145.69MHz or telnet://dxc.k1ttt.net
> -----Original Message-----
> From: towertalk-bounces at contesting.com [mailto:towertalk-
> bounces at contesting.com] On Behalf Of Dave Fuller
> Sent: Monday, September 11, 2006 20:52
> To: TTalk
> Subject: [TowerTalk] Tic ring feeline
>
> How about some proven methods of running the feedline to a beam on a Tic
> ring?
>
> -Dave NN5K
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
More information about the TowerTalk
mailing list