[TowerTalk] rotor

[sabrams at nycap.rr.com]

Dave, I will send you my data as promised , but KK9A is correct about the 
point to point wiring.

By the way, the Telrex rotator runs 110v to the tower for the rotator and 
the selsyn.  I have a BA2345RIHS 2-inch rotator (with an internal heater in 
the metal box) and Telrex recommends size 18 wire for terminals 1, 
9,10,11,and 12; size 12 for terminals 2,3, and 4; and size 14 for terminals 
5,6,7 and 8.  My manual for the 3-inch rotator has the same wiring 
requirements.  It just occurred to me that the rotator has NO fuse.  I am 
going to install a fuse on each leg of the incoming AC.  My motor shows 
current requirements of 4.5/2.5 amps so I will first try some 5 amp 
slo-blows and see what happens.  73  Saul  K2XA

----- Original Message ----- 
From: <john at kk9a.com>
To: <TOWERTALK at contesting.com>
Cc: <w5kow5ko at yahoo.com>
Sent: Saturday, August 04, 2007 8:10 PM
Subject: [TowerTalk] rotor


>I have a Telrex rotator and I also do not have a wiring diagram.  I don't
> recall having any difficulty wiring it up.  Doesn't it have a numbered
> terminal strip on both the control box and rotator where you can hook up
> terminal 1 to terminal 1, 2 to 2, 3 to 3, etc?
>
> KK9A.
>
>
>
> To: towertalk at contesting.com
> Subject: [TowerTalk] rotor
> From: dave streight
> Date: Fri, 3 Aug 2007 18:54:56 -0700 (PDT)
> List-post: <mailto:towertalk at contesting.com>
>
> i have a telrex rotor i need info. on.   it it is a model# A1312RISX  .
> need
> the wire digram
>  it has two selsyn motors one in the control box and one at the rotor . i
> cant
> find any info any
>  where maybe some one can help  thanks  dave  w5ko
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>