[TowerTalk] Can't guy at normal 120 degree spots????

[jeremy-ca]

Use the standard GA25GD guy bracket and drill holes in the sides for the 
required 120* pattern. Use a HD 3/8 ring bolt thru the holes and to attach 
the guys. Not perfect but it works.

Carl
KM1H



----- Original Message ----- 
From: "Tim Heger" <n3xx at charter.net>
To: <TowerTalk at contesting.com>
Sent: Sunday, August 12, 2007 10:39 AM
Subject: Re: [TowerTalk] Can't guy at normal 120 degree spots????


> Maybe you could use Torque Arm Assemblies at each guying level.  Guys 
> could
> be attached to the three corners, leaving the tower at 60 degrees off from
> the normal guying directions.
>
> GL - 73, Tim - N3XX
>
> ----- Original Message ----- 
> From: "Joe Eide" <jeide at execpc.com>
> To: <towertalk at contesting.com>
> Sent: Sunday, August 12, 2007 9:48 AM
> Subject: [TowerTalk] Can't guy at normal 120 degree spots????
>
>
>> Hello,
>>
>> I have a situation where I can't guy at the normal 120 degree angles
>> which are directly in line with each of the 3 legs on a Rohn 25G.
>>
>> Has anyone come up with a solution, like maybe some sort of ring that
>> would allow attaching guys at different 120 degree points??
>>
>> Thanks for your opinions,
>>
>> Joe - KB9R
>> _______________________________________________
>>
>>
>>
>> _______________________________________________
>> TowerTalk mailing list
>> TowerTalk at contesting.com
>> http://lists.contesting.com/mailman/listinfo/towertalk
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>