[TowerTalk] Another ROHN 45 Question

[Dick, W1KSZ]

What !!!???
With my new Bionic Knees I can do anything.

73, Dick

jeremy-ca wrote:
> Dick is not built to stand up there! Gotcha Dick! When's the move?
> 
> Carl
> KM1H
> 
> 
> ----- Original Message ----- 
> From: <hdmc38 at bellsouth.net>
> To: "Dick, W1KSZ" <w1ksz at earthlink.net>; "TowerTalk" 
> <towertalk at contesting.com>
> Sent: Saturday, August 25, 2007 10:11 AM
> Subject: Re: [TowerTalk] Another ROHN 45 Question
> 
> 
>> Good morning Dick
>>
>>        The G-1000SDXA will bolt up to the plate or the 45AG4? top section. 
>> I run a similar set up that uses the Rohn TB-3 thrust bearing bolted to 
>> the top section. Another plus is you can stand on the tower top section. 
>> Hope this helps.
>>
>>                          73 Joe K4XZ
>>> From: "Dick, W1KSZ" <w1ksz at earthlink.net>
>>> Date: 2007/08/25 Sat AM 08:24:33 EST
>>> To: TowerTalk <towertalk at contesting.com>
>>> Subject: [TowerTalk] Another ROHN 45 Question
>>>
>>> Will the AS455G Accessory shelf accommodate the YAESU
>>> G-1000 Rotator without additional drilling ?
>>>
>>> If you must know why I picked the YAESU, it's because
>>> the FT-2000D DMU has that neat rotot control app.
>>> -- 
>>> 73, Dick, W1KSZ
>>> _______________________________________________
>>>
>>>
>>>
>>> _______________________________________________
>>> TowerTalk mailing list
>>> TowerTalk at contesting.com
>>> http://lists.contesting.com/mailman/listinfo/towertalk
>>>
>> JOE PATRICK
>> SENIOR PLUMBING/MECHANICAL
>> INSPECTOR CITY OF BOYNTON BEACH
>>
>> _______________________________________________
>>
>>
>>
>> _______________________________________________
>> TowerTalk mailing list
>> TowerTalk at contesting.com
>> http://lists.contesting.com/mailman/listinfo/towertalk
>>
> 
> _______________________________________________
> 
> 
> 
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
> 

-- 
73, Dick, W1KSZ