[TowerTalk] Rohn Trust Bearing/an ounce of prevention....

[Bill Parry]

Replacing those bolts sounds like a good idea. Perhaps I should assume that
my tower guy is going to be able to remove those bolts and purchase some SS
ones. I got my Rohn book last night and looked up the TB3.  Unfortunately,
it does not show the size of those bolts. Do any of you fellows have the
specs on the bolts?

Bill, W5VX

-----Original Message-----
From: towertalk-bounces at contesting.com
[mailto:towertalk-bounces at contesting.com] On Behalf Of Roger (K8RI)
Sent: Wednesday, December 05, 2007 12:52 AM
To: Cqtestk4xs at aol.com; TOWERTALK at contesting.com
Subject: Re: [TowerTalk] Rohn Trust Bearing/an ounce of prevention....




> The key here is to throw away those ratty bolts Rohn gives you with the
> thrust bearing before you install it..  Replace them with stainless steel 
> AND put
> Penetrox or some anti-oxidant on the bolt so it won't freeze.  It  worked 
> for
> me!

That's the way I do it as well, plus the addition of a locking nut. I use a 
*little* Never Seize or a little of plain old Moly Disulphide grease. Just 
enough to keep the threads from gauling (sp?)

Roger (K8RI).

>
> Bill K4XS/KH7XS
>
>
>
> **************************************Check out AOL's list of 2007's 
> hottest
> products.
> (http://money.aol.com/special/hot-products-2007?NCID=aoltop00030000000001)
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk 

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk at contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk