[TowerTalk] new tower

jeremy-ca km1h at jeremy.mv.com
Fri Jul 13 21:34:21 EDT 2007


It minimizes the tower twisting forces especially at the base. Recommended 
by Rohn. Especially advantageous with a tall tower with a big load; lets the 
guys do the work. Ive been on the top of my tower with a strong wind blowing 
and with the 1/4" EHS it barely moves.

Carl
KM1H


----- Original Message ----- 
From: "Mark Robinson" <markrob at mindspring.com>
To: "jeremy-ca" <km1h at jeremy.mv.com>; "Paul Hemby" <phemby at hotmail.com>; 
<towertalk at contesting.com>
Sent: Friday, July 13, 2007 8:00 PM
Subject: Re: [TowerTalk] new tower


> What is the advantage of a pier pin base?
>
>
> 73's de Mark N1UK G3ZZM
>
>
> ----- Original Message ----- 
> From: "jeremy-ca" <km1h at jeremy.mv.com>
> To: "Paul Hemby" <phemby at hotmail.com>; <towertalk at contesting.com>
> Sent: Friday, 13 July, 2007 7:56 PM
> Subject: Re: [TowerTalk] new tower
>
>
>> 1. What do you plan to put on it?
>>
>> 2. Id strongly suggest a pier pin base no matter what sort of guying.
>>
>> 3. I have 180' of 45G up 17 years and it has withstood hurricanes,
>> northeasters, microbursts, severe icing, etc. And that was with a 4 stack 
>> of
>> 40' booms on 20 and 4/4 40M KLM's. I dont even count the several 20' tall 
>> 2
>> way radio sticks, plus the 20' mast and a 38' boom 6M yagi.
>> I use 1/4 EHS guys at 70% of height.
>>
>> Carl
>> KM1H
>>
>>
>> ----- Original Message ----- 
>> From: "Paul Hemby" <phemby at hotmail.com>
>> To: <towertalk at contesting.com>
>> Sent: Friday, July 13, 2007 5:26 PM
>> Subject: [TowerTalk] new tower
>>
>>
>>>I would like to install 170 feet of Rohn 45 tower.  The problem is that 
>>>the
>>> specs call for guy points to be 136 feet.  My lot is only 170 feet wide
>>> which will give me about 96 feet on each guy point.  Is there anyway to
>>> elevate the guy points enough, such as using H beam to make this work, 
>>> or
>>> increasing the size of the guy cables, pouring additional concrete, etc,
>>> the
>>> tower can be bracketed to the poured concrete bond beam on a concrete
>>> block
>>> garage at 10 feet if this would help.  Any help or ideas would be
>>> appreciated.   Thanks Paul WN4AMO
>>>
>>>
>>> _______________________________________________
>>>
>>>
>>>
>>> _______________________________________________
>>> TowerTalk mailing list
>>> TowerTalk at contesting.com
>>> http://lists.contesting.com/mailman/listinfo/towertalk
>>>
>>
>> _______________________________________________
>>
>>
>>
>> _______________________________________________
>> TowerTalk mailing list
>> TowerTalk at contesting.com
>> http://lists.contesting.com/mailman/listinfo/towertalk
>
> 



More information about the TowerTalk mailing list