[TowerTalk] Rohn 45 Tower

[jeremy-ca]

If you have the room for a back guy why do you need a I beam?
The beam should be the height that is calculated the guy wire would be at 
in a full length run.

For a 100' of 45G and not insanely overloaded then guy points at 65-75' 
would be sufficient.

Carl
KM1H



----- Original Message ----- 
From: "Ron Todd" <ron at k4wz.com>
To: <towertalk at contesting.com>
Sent: Friday, June 29, 2007 11:44 AM
Subject: [TowerTalk] Rohn 45 Tower


>
> I am installing 90 to 100 feet of Rohn 45 very soon.
> My property is  125 wide and have trees and water lines, and power lines 
> in the way.
> I want to go out 80 feet for my guys.
> I will be using 10 foot I beams to connect the guys to.  4 foot in cement.
> I plan on back guying the I beams also.
> Question,  Do I measure my 80 feet at the I beam or the end of my back guy 
> ?
>
> Ron K4WZ
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>