[TowerTalk] Prosistel PST61 in Triex 470

[David J Windisch]

Fwiw, it takes a face-width of around 24 inches to fit completely inside a 
section.  I have one in an 18 inch faced tower, its motor hangs out one 
side, and does a fine job of turning a TH11/402CD stack.   If you have an 
older one, put a bonnet on the mast to keep water out of the exposed bearing 
on the top.
73, Dave, N3HE

----- Original Message ----- 
From: "Saad Mahaini" <n5ff at tx.rr.com>
To: <towertalk at contesting.com>
Sent: Sunday, March 04, 2007 9:19 AM
Subject: [TowerTalk] Prosistel PST61 in Triex 470


>
> Hello,
>
> Has anyone installed the Prosistel PST61 rotor in the TriEx 470 Crank up
> tower?  I appreciate any info on this.
>
> 73, Saad N5FF
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk