[TowerTalk] ferrite beads was...Re: [RFI] HIGH POWER and RFI...

[Marlon K. Schafer]

LOL  Thanks!  Um, I think.  hehehehe

OK, lets try this again.  I'm a computer geek.  I use radio gear that's 
already built and programmed for frequency etc.  It's also very robust and 
isn't normally effected by any of this.

I've got 1.5 years of electronics under my belt and a life time of working 
with electricity.  But I've not dug this deep into the issue since I was in 
college almost 2 decades ago.

Having said all of that, can someone tell me EXACTLY what kind of beads I 
should run on cat5e to make sure that the only signal that gets through is 
what's supposed to?

Sorry for being so dense (and, admittedly, a bit lazy).

thanks
marlon

----- Original Message ----- 
From: "Chuck Sudds" <chuck at dxham.net>
To: <towertalk at contesting.com>
Sent: Saturday, March 10, 2007 8:44 AM
Subject: Re: [TowerTalk] ferrite beads was...Re: [RFI] HIGH POWER and RFI...


At 08:27 AM 3/10/2007 -0800, Marlon wrote:

Marlon

Check here:    http://www.audiosystemsgroup.com/RFI-Ham.pdf

Page 13 lists a bunch.  Good luck!  I know that I'll need it myself
;)  (Thanks, Jim!)

Chuck  KØTVD


>Where do I find those freqs?  I've looked on google but haven't found any
>good data that I can understand.
>thanks
>marlon


_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk at contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk