[TowerTalk] Help with Moving a C3

[David Robbins K1TTT]

If its relatively new hopefully it has stainless hardware and hasn't welded
itself together.  On smaller antennas like that I would normally take the
elements off the boom, just tape them to it and tie that to a roof rack.  In
most cases a small wrench(not wench or winch) is enough on newer antennas,
old rusted ones may require bolt cutters to take apart.

If its much longer than your car maybe take the elements and boom apart in
the middle.  Be sure to take a marker to mark the order on the boom and the
joints you take apart so you remember how they match up.


David Robbins K1TTT
e-mail: mailto:k1ttt at arrl.net
web: http://www.k1ttt.net
AR-Cluster node: 145.69MHz or telnet://dxc.k1ttt.net
 

> -----Original Message-----
> From: towertalk-bounces at contesting.com [mailto:towertalk-
> bounces at contesting.com] On Behalf Of Mark Adams
> Sent: Sunday, March 25, 2007 14:18
> To: towertalk at contesting.com
> Subject: [TowerTalk] Help with Moving a C3
> 
> Hi Gang,
> 
> Later this week I'll be moving a C3 from the home of an SK to my
> QTH.  It is only been up a couple years (and it'll sure look good on
> my 55' tower!)
> 
> I have a roof rack and can split the elements for xport. But what is
> the BEST procedure for doing so? I'd like to make as little work as
> possible on the rebuild end. What tools, rivets, etc should be used
> for re-assembly?
> 
> TIA,
> Mark K2QO
> Clarence, NY
> _______________________________________________
> 
> 
> 
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk