[TowerTalk] Guy cable questions
Clint Talmadge
unclebudd at bellsouth.net
Tue May 22 10:02:29 EDT 2007
A option for question #2 is an inexpensive 4" Hand Grinder. They can be had for bout $20 at some of the surplus tool stores (Northern Tool etc) and when fitted with a Cutting wheel, will go through EHS Guy wire with no effort. I wrap the area I want to cut with Duct tape to keep the strands from flaring out. Cutting with a Bolt Cutter, even a sharp one and the rock idea will leave you with a very messy and hard to work with end.
For question #1 the Loos answer is correct.
Clint - W5CPT
----- Original Message -----
From: Ken Bessler
To: towertalk at contesting.com
Sent: Tuesday, May 22, 2007 1:00 AM
Subject: [TowerTalk] Guy cable questions
I'm in the middle of a Rohn 25g tower installation and I've got
two questions:
1) How do you know when you've got 400#'s of tension on the guy wires?
2) How do you cut 3/16" 7x19 cable? The stuff just laughs at my wire
cutters!
73's de Ken KG0WX - Kadiddlehopper #11808,
Flying Pigs #-1055, Grid EM17io
_________________________________________________________________
More photos, more messages, more storage-get 2GB with Windows Live Hotmail.
http://imagine-windowslive.com/hotmail/?locale=en-us&ocid=TXT_TAGHM_migration_HM_mini_2G_0507
------------------------------------------------------------------------------
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk at contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
More information about the TowerTalk
mailing list