[TowerTalk] N-Connector to Super 8 Low Loss Cable?

[Steve Katz]

Yes, you need a different center pin.  The "correct" type N connectors to
fit the #10AWG and #9.5AWG center conductor cables like 9913, LMR400, etc.
are readily available from several sources, and they are not the standard
mil-spec UG21D/U type.  The Amphenol 82-202-1006 fits, as do the RFN1006-31
crimp type N and several others.  The R.F. Connection in MD stocks all this
stuff.  Joel at R.F. Connection "used" to sell just the specialty center pin
and rear gasket so a convention N connector could be retrofit for oversized
conductors as their P/N "9913/SET" but I'm not sure if he still does.
-WB2WIK/6

-----Original Message-----
From: Eric - VE3GSI [mailto:ve3gsi at sympatico.ca]
Sent: Wednesday, October 24, 2007 10:10 AM
To: Towertalk e-Goups
Subject: [TowerTalk] N-Connector to Super 8 Low Loss Cable?


Are there any tricks any of you fellows can suggest for putting the pin of
an N-Connector on centre conductors of Super 8 Cable?
 
This is the first time I have tried this combination and found the centre
conductors of the cable too large for the pin. I am making up a jumper cable
for the top of my tower to go from the beam to the hard-line.
 
I have used these same connectors on RG-213 with no problem, so perhaps
there is a different connector model I should purchase. Just not sure!
 
Tnx,
Eric - VE3GSI
 
 
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk at contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk