[TowerTalk] HDR-300 Drilling Template Needed

Roger (K8RI) K8RI-on-TowerTalk at tm.net
Fri Apr 18 16:47:53 EDT 2008


DENNIS BRICKEY wrote:
> Does anyone have a drilling template for an HDR-300?  I'd sure appreciate the help!  Thanks, 
>
>   
Place rotator upside down and anchor in place (Vise?), Take the 
cardboard backing off a paper tablet and place over the bottom of the 
rotator.  *Lightly* tap (don't want to destroy the threads) with a 
ballpeen hammer around the edges of the bolt holes being careful not to 
move the cardboard.  It might take a couple for practice but done 
properly it will cleanly cut holes that line up with the bolt holes in 
the rotator base and make an excellent, temporary template.   It's also 
a good way to make gaskets.  Don't forget "top and bottom" of the template.

73 and good luck,

Roger (K8RI)
> Dennis N4DD
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>   



More information about the TowerTalk mailing list