[TowerTalk] MFJ noise canceler and Ten Tec Orion I

[George Gorsline VE3YV]

Mike - sorry, no experience with the Orion.  Would depend on how the RX antenna port is wired.  For the MP series there are both RX IN and RX OUT jacks, which allows you to `insert` the noise canceler into the RX circuit.  GL

-- 

73,  George VE3YV / K8HI



Message: 1
Date: Fri, 25 Apr 2008 12:44:01 -0500
From: "Mike Bragassa" <bragassa at consolidated.net>
Subject: [TowerTalk] MFJ noise canceler  and Ten Tec Orion I
To: <towertalk at contesting.com>
Message-ID: <000901c8a6fb$f2873b10$0300a8c0 at MAIN>
Content-Type: text/plain; format=flowed; charset="Windows-1252";
	reply-type=original

George, VE3YV:

Can you offer any information like below for the Ten Tec Orion I?

I use my "Receive"  antenna port for my Beverages,

73, Mike K5UO
.........................................................<<>>.............................................
Message: 2
Date: Thu, 24 Apr 2008 13:54:00 -0400
From: George Gorsline VE3YV <ve3yv at pathcom.com>
Subject: [TowerTalk] Noise Canceller Hookup
To: towertalk at contesting.com
Message-ID: <4810C938.4070102 at pathcom.com>
Content-Type: text/plain; charset=ISO-8859-1; format=flowed

Peter - it`s easier than that - the Mark-V has all of the connections
needed for you to use it without having the MFJ unit TR switch.  See the
following diagram which is for another unit, but the connections are the
same.  It takes a couple of minutes to follow it - not as intuitive as
you might think (or I was having a dense day).  With this in place, to
use the noise canceller, just push the RX antenna button.

http://www.va3cr.net/accessories/ANC-4.htm