[TowerTalk] M2 2800 question
K7LXC at aol.com
K7LXC at aol.com
Mon Aug 25 08:51:54 EDT 2008
In a message dated 8/24/2008 9:02:02 P.M. Pacific Daylight Time,
towertalk-request at contesting.com writes:
> I'm getting ready to install my new M2 2800 rotor. I ordered one of
Champion Radios mast clamp for the rotor. I'm wondering if I should put the
little "centerer" peice that M2 sends with the rotor. I thought I read
somewhere that it also keeps that bolt from backing out. Is this true?
Umm, my first thought would be to contact Champion Radio Products. I'm
sure what they'll tell you is to leave the small bolt and bushing in the top
of the turntable and that the Champion clamp has a hole in the middle to
accommodate it. You don't need the centering pyramid; the clamp will self-center a
2" mast.
With the bolt not installed, I found that water stands in the turntable
hole indicating to me that there's a bottom to the hole so no harm if it
isn't installed.
Cheers,
Steve K7LXC
TOWER TECH
and
Champion Radio Products
_www.championradio.com_ (http://www.championradio.com)
Cell: 206-890-4188
**************It's only a deal if it's where you want to go. Find your travel
deal here.
(http://information.travel.aol.com/deals?ncid=aoltrv00050000000047)
More information about the TowerTalk
mailing list