[TowerTalk] HAM IV Question

[Cqtestk4xs at aol.com]

> Larry K3VX
It's not too difficult, but it is tedious. When you open  it, do it in or 
in/over a box or tub, else you'll be chasing ball bearings  til the code 
requirement comes back.
73,
Mike  NF4L
_______________________________________________
 
That reminds me of the time I opened up a HamM rotor on top of a roof (back  
in the early 70s), not knowing what was inside.  I soon found out....about  a 
hundred or so greasy bearings that rolled down the tile roof in a clatter and  
off into the tall grass, never to be found.  All other rotors have been  
opened up on the bench since then!
 
Bill KH7XS/K4XS
**************Make your life easier with all your friends, email, and 
favorite sites in one place.  Try it now. 
(http://www.aol.com/?optin=new-dp&icid=aolcom40vanity&ncid=emlcntaolcom00000010)