[TowerTalk] FW: Hy-Gain Rotor Box Schematic

[Don Bozarth]

Nope... page 15 (the scematic) doesn't show the switch... nor does the shot 
of the rear panel.(fig 12).  This is not the calibrate pot on the front, but 
the NOR/CAL switch on the reear panel.

Don B.

----- Original Message ----- 
From: "Jim Hargrave" <w5ifp at gvtc.com>
To: "Tower" <towertalk at contesting.com>
Sent: Tuesday, December 09, 2008 12:12 PM
Subject: [TowerTalk] FW: Hy-Gain Rotor Box Schematic


>
>
>
> Dick,
>
> Its shown in the HyGain manual. Its available in PDF form from the HyGain
> web site.
>
> http://www.hy-gain.com/man/pdf/HAM-IV.pdf
>
>
>   * 73's Jim W5IFP *
>
>
>   >-----Original Message-----
>   >From: towertalk-bounces at contesting.com
>   >[mailto:towertalk-bounces at contesting.com]On Behalf Of RICHARD SOLOMON
>   >Sent: Tuesday, December 09, 2008 7:43 PM
>   >To: TowerTalk
>   >Subject: [TowerTalk] Hy-Gain Rotor Box Schematic
>   >
>   >
>   >
>   >Is there a reason why the HAM-IV Manual I downloaded
>   >from the MFJ site does not show the Calibrate Switch on
>   >the schematic ??
>   >It seems a simple enough thing to show, it has been part
>   >of the Control Box for eons !!
>   >Very discouraging ....
>   >
>   >73, Dick, W1KSZ
>   >_______________________________________________
>   >
>   >
>   >
>   >_______________________________________________
>   >TowerTalk mailing list
>   >TowerTalk at contesting.com
>   >http://lists.contesting.com/mailman/listinfo/towertalk
>   >No virus found in this incoming message.
>   >Checked by AVG - http://www.avg.com
>   >Version: 8.0.176 / Virus Database: 270.9.15/1839 - Release
>   >Date: 12/9/2008 9:59 AM
>   >
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk