[TowerTalk] cleaning aluminum beam elements

markrob at mindspring.com markrob at mindspring.com
Sat Feb 16 12:35:20 EST 2008


I like to use fine 400 grade wet and dry paper with kerosene as a lubricant. 
WD40 works well too

Steel wool may leave pieces of steel embedded in the aluminum which will rust later


Mark N1UK G3ZZM

-----Original Message-----
>From: Artmouton <k5fnq at cox.net>
>Sent: Feb 16, 2008 12:11 PM
>To: towertalk at contesting.com
>Subject: [TowerTalk] cleaning aluminum beam elements
>
>I am putting up a used Cushcraft A3S (with 4- meter kit) that was up for a 
>few years (local conditions in S. Louisiana with salt air and usual crud) do 
>that it has the usual tarnish, dirt, etc on the elements.
>
>Local suggested cleaning it with steel wool and soap and water.
>
>I intend to break each section down, clean it, open the traps, replace any 
>bad end caps, remeasure and re-construct.
>
>Just wondering if there were any other suggestion from the group?
>Art K5FNQ
>
>_______________________________________________
>
>
>
>_______________________________________________
>TowerTalk mailing list
>TowerTalk at contesting.com
>http://lists.contesting.com/mailman/listinfo/towertalk



More information about the TowerTalk mailing list