[TowerTalk] RG-6 connector issues/ rcv array

[Mike Fatchett W0MU]

I can't recall if I used their tools but it is the same compression
connectors and compression tool.  These are the same tools and connectors
that the satellite companies use when they install a dish at your home. 

-----Original Message-----
From: towertalk-bounces at contesting.com
[mailto:towertalk-bounces at contesting.com] On Behalf Of Doug Renwick
Sent: Friday, January 18, 2008 7:21 PM
To: 'W3YY'; towertalk at contesting.com
Subject: Re: [TowerTalk] RG-6 connector issues/ rcv array

Bob,

I used tools and supplies very similar to those used by DX Eng. and if
correctly installed, provide a very good connector installation.

Doug


Subject: Re: [TowerTalk] RG-6 connector issues/ rcv array

Mike -

Are you using the connectors, crimp tool, and cable supplied by DX
Engineering?  I have their crimp tool and connectors but found them very
hard to use and was not confident about the resulting installation.  In
defense of DX Engineering I have not contacted them and discussed the issue,
I just gave up and used the RG-6 connectors I'm used to.  Just curious what
you're using.

73, Bob - W3YY



_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk at contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk