[TowerTalk] TB3 Thrust Bearing - Wrench Size

[Roger (K8RI)]

Jerry K wrote:
> Rich, I emailed you a list of the sizes and details for every nut and 
> bolt on the tower. I just found it in a file folder out in the shop 
> yesterday. Sorry I didn't give it to you earlier.
> 73, Jerry W5KP
>   

You are making the assumption that the stock bolts were used in each 
case. <:-))
But I hope you are correct.

73

Roger (K8RI)
> rmthorne at suddenlink.net wrote:
>   
>> After following the bearing thread I've decided to remove mine while being stored in the horizontal position.
>>
>> Can anyone tell me what size wrench is needed to remove the bolts/nuts?  I have mine stored in the country and it would be nice to know what size wrenches I need to take with me vs the entire wrench set.
>>
>> Thanks
>>
>> Rich - N5ZC
>> _______________________________________________
>>
>>
>>
>> _______________________________________________
>> TowerTalk mailing list
>> TowerTalk at contesting.com
>> http://lists.contesting.com/mailman/listinfo/towertalk
>>
>>   
>>     
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
>