[TowerTalk] Equalizer Plates

Jerry K w5kp at hughes.net
Wed Nov 26 08:01:56 EST 2008


The three-hole equalizer plates supplied by Rohn for my 45G came with 
stout stamped steel galvanized jam nuts, no mention of staking. I used 
the jam nuts, of course, but added Loctite 262 on the main nuts as well. 
and of course figure 8 EHS loops. Seven years later I was able to 
disassemble everything undamaged by using very serious torque, but 
without using heat. Nothing was loose, the Loktite and the jam nuts both 
did their job. For a tower on attended private property I'd pass on 
staking, but I would use Loktite 262 and jam nuts of some kind. If the 
tower is accessible by the public I'd consider staking things, though, 
and in either case I'd definitely use figure 8 EHS through the 
turnbuckles and anchors. The anchor points and lower 15' or so of guys 
are really the only vulnerable points for vandalism or casual damage.
Jerry W5KP

jimlux wrote:
> Drax Felton wrote:
>   
>> The instructions with my Rohn equalizer plates say to "Stake All Nuts After
>> Assembly."
>>
>> What does that mean?  I know to run some wire through the turnbuckles, but
>> this is about the nuts holding the turnbuckles to the equalizer plates.
>>
>> How do I stake a nut?
>>     
> Originally, you'd take a chisel and deform the threads on the bolt right 
> where the nut is so that the nut cannot turn.
>
> These days, it's putting a blob of suitable epoxy on the bolt/nut.
>
> I suspect any decent adhesive threadlocker (LocTite red) would work.
>
> SO would wiring the nut and bolt, if they're appropriately drilled for it.
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
>   


More information about the TowerTalk mailing list