[TowerTalk] US Tower Anchor Bolts

[Eugene Jensen]

Call  Portland  Bolt http://www.portlandbolt.com/ and they ship what ever 
you want and like all these outfits they make them and either in house Galv. 
them or send out . Also go to http://www.thomasnet.com/ and search under 
Bolts and Nuts. I used a outfit in the Bronx that sells only commercial 
outfits for all the bolts and anchors for my Rohn SSMW and we spent around 
$500.00 on the whole order. The anchor were by them selves 4 feet long and 1 
inch with nuts were $220.00 and there were 12 of them. they took a week for 
them to be made and Galv.


----- Original Message ----- 
From: "Mark Robinson" <markrob at mindspring.com>
To: <towertalk at contesting.com>
Sent: Sunday, September 21, 2008 7:33 PM
Subject: [TowerTalk] US Tower Anchor Bolts


>I am getting ready to install the base for a US Towers HDX-589MDPL crank up
> tower. I know that US Tower supplies ungalvanized 1 1/8 OD by 27 inch
> straight anchor bolts. I think that there was a thread a while back about
> using galvanized anchor bolts with a J bend at the embedded end. Does 
> anyone
> know of a source of such anchor bolts.
>
>
> 73 Mark N1UK
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk