[TowerTalk] g-800sdx rotor

[Dennis Vernacchia]

John,

I just pulled my connector off back of G-800SDX control box

Pin   Wire Color

1 - Blue
2 - Grey
3 - Black
4 - Brown
5 - Green
6 - No connection

Pins 1 thu 3 use smaller gauge wire ( 20 or 22 AWG ) than Pins 4 and 5 ( 16
or 18 AWG )


For future reference - as you look a the rear of the control box

Pin 1 is in Upper Right of connector
Pin 2 is Lower Right
Pin 3 is Middle of Top Row
Pin 4 is Middle of bottom Row
Pin 5 is in Upper Left
Pin 6 is in Lower left ( Not used )

73 Dennis N6KI


On Wed, Feb 25, 2009 at 11:19 AM, John Hudson <jd_hudson at comcast.net> wrote:

> I have a used g-800sdx and the original connector on the back of the
> controller has been changed out and what I looking for is to verify the
> pinout from the box to the rotor connector
>
>
>
> On the inside of the controller box there GREEN, BLACK, BLUE, BROWN and
> GRAY
> wires. What pins to the rotor connector do they go to
>
>
>
> I don't trust the current pinout on the connector but want to the verify
> before wiring up
>
>
>
> Thanks
>
>
>
>
>
> 73
>
>
>
> John
>
> KO4XJ
> www.w4nja.org/ko4xj.htm
>
>
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>