[TowerTalk] common winch mounting holes?

[Al Williams]

As I remember, when I replaced the k1550 with the k2550, I had to file two 
of the mounting plate holes a bit (maybe 1/4" on one side).  Other than that 
everything fit.

k7puc


----- Original Message ----- 
From: "luke webber" <luke_webber at hotmail.com>
To: <towertalk at contesting.com>
Sent: Friday, November 13, 2009 8:21 AM
Subject: [TowerTalk] common winch mounting holes?


>
> Hello everyone
>
>
>
> im hoping you can help educate me on the options i might have for 
> replacing a Fulton K1550 winch.  Are the mounting holes for that winch 
> similar to other winches?  Just curious to know if i have to modify the 
> mounting location.
>
>
>
> I heard that Dutton Lainson has similar winches with similar bolt hole 
> locations...are there any others for that size of winch?
>
>
>
> Thanks in advance for the help
>
> _________________________________________________________________
> Hotmail: Trusted email with powerful SPAM protection.
> http://clk.atdmt.com/GBL/go/177141665/direct/01/
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk