[TowerTalk] New Tower installation

[Michael Ryan]

I would install at an angle, if not sooner or later they are going to want
to lean in the direction of the tower at the angle they were supposed to be
installed at in the first place. You will constantly be re-tightening your
guy wires.  - Mike

-----Original Message-----
From: towertalk-bounces at contesting.com
[mailto:towertalk-bounces at contesting.com] On Behalf Of Dave
Sent: Saturday, November 14, 2009 1:01 PM
To: towertalk at contesting.com
Subject: [TowerTalk] New Tower installation

I have just put up a Rohn 25G.  My question is, and I haven't researched the
archives due to the  interest of time before the snow blows. Can I use the
3/4" x 4' screw anchors with 6" blade to secure the tower with out using
cement.  If I just screw them in all the way straight down, no angle,  will
they hold, or do I need to angle them at 50 deg. as stated in the Rohn
spec's.
I would like some feedback on this way of doing it.  These things are
suppose to hold trailers down.  Are they reliable enough for the tower.
Wind load on the only beam is 6.9 sq. ft. with a 10' 2" mast.
 
Thanks, Dave
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk at contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

__________ Information from ESET NOD32 Antivirus, version of virus signature
database 4607 (20091114) __________

The message was checked by ESET NOD32 Antivirus.

http://www.eset.com


 

__________ Information from ESET NOD32 Antivirus, version of virus signature
database 4607 (20091114) __________

The message was checked by ESET NOD32 Antivirus.

http://www.eset.com