[TowerTalk] broken balun wires

n8de at thepoint.net n8de at thepoint.net
Thu Jan 14 15:21:01 PST 2010


I agree with Bill, and would suggest you bend those wires into a "S"  
shape before connecting them to the feed point of the antenna.  This  
will minimize strain on both ends of the wires.

73
Don
N8DE

Quoting Bill K2OWR <k2owr at comcast.net>:

> :::: You were not crimping the lug?
> I would crimp it AND solder it.
>
>
> ----- Original Message -----
> From: "Ken Eigsti" <diverken at chaffee.net>
> To: <towertalk at contesting.com>
> Sent: Thursday, January 14, 2010 18:02
> Subject: [TowerTalk] broken balun wires
>
>
>> Here is my problem.
>> I have a Force 12 C36XN and I use a Force 12 balun with the 2 wires
>> (3.5"each ) that exit one end of the balun and connect to the antenna. (40
>> meter portion)
>>
>> Twice in less than a year, the wire has broken where I have it soldered to
>> a
>> spade lug that connects to the terminal on the antenna.
>> Obviously the vibration is breaking the wire at the solder joint on the
>> lug.
>>
>> What is the best method to prevent this? Crimping the wire on the lug? No
>> solder?  Luckily I can reach the balun/connections by leaning out from the
>> tower.
>>
>> Any thoughts?
>>
>> Thanks
>> Ken W0LSD
>> _______________________________________________
>>
>>
>>
>> _______________________________________________
>> TowerTalk mailing list
>> TowerTalk at contesting.com
>> http://lists.contesting.com/mailman/listinfo/towertalk
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>





More information about the TowerTalk mailing list