[TowerTalk] Swinging gate, 3" thrust bearing

[David J Windisch]

Yet another project that isn't going to happen.

All-aluminum welded construction. 

Fits 18"-face tower, eg, Rohn 45.  

Gate swing is around 240 degrees.

One platform/shelf for rotator, one platform/shelf for thrust bearing holding top of gate.  Platforms are 3/16" thick trapezoids, 16-1/2" base-1, 7-1/2" altitude, 14-1/2" base-2.  Support arms are 1" x 2" x 24", 1/8" walls.

Long gate side is 48", 2" od, 1/8" wall.  Short gate side is 27", 2" od, 1/8" wall.  Long-short spacing is 27" center-to-center.  Long and short sides are connected by 2" x 2" square tubes.

3" Unarco-Rohn brg included for top support of gate.

I have some pictures.  Email me off-reflector: davidjw  _at-  cinci dot rr dot com

You supply U-bolts and other hardware.

I ship conus for $350 ono.

Tks for reading.

Brgds,
Dave Windisch, W8FGX
513-674-7202 any time