[TowerTalk] US Tower IV-16 Inverted V mount issues

[Eric Dobrowansky K2WD]

  Anyone using the US Tower IV-16 inverted V bracket?  



I have one installed here, and have already seen it spin around approx.  90-120 degrees  while rotating the antenna stack, and it almost yanked my dipole to shreads.   



Has anyone experienced this, and solved it, by using some sort of lubricant between the mast and IV mount?   Maybe grease like that which is put into the thrust bearing via the fitting? Or some other sort of lubricant? 



Otherwise,    I think I will be lowering the tower and moving the dipole pulley off the IV16 and re-attaching it to one of the cross-members of the upper section.  I used that method on my last tower for years. Just need an extra hand to hold the ropes away from the tower face when raising or lowering the tower. But at least you can turn the antenna stack without the fear of tearing up the wire antennas.   Then, the next time I bring the tower horizontal, trash the darn IV-16..... 



Eric 

K2CB