[TowerTalk] DX eng
Jim Thomson
jim.thom at telus.net
Sun Jul 25 17:18:02 PDT 2010
The only one that stood out, miles above the rest has been DX Engineering.
## Ever since 911, box's from the usa take a lot longer to arrive in
Canada.
## Except for DX eng. I ordered a ton of stuff, like a case load of those
super mast clamps,
etc, on line at 2 AM on a thursday.. and they were all shipped before I
even gotta out of bed !
They arrived the following wed, pristine condx ! Same deal with the other
4 x caseloads of parts
from DX eng, over the last 18 x months... including dozens of SS saddle
clamps, dacron rope, etc.
Their kit for installing PL-259's really fast is superb, the best. It
makes installing PL-259's a breeze.
## The coax cable cutter they sell, made by channel lock, is deluxe. It's
cuts RG-213 better than
any heavy duty side cutter's ever did. A 8 yr old girl can use em with 2
x finger's. I also used em to lop
off 2 ga stranded cu grnd wire that was in the way of the new tower base.
Effortless.
## I'm going to try an experiment with a new boom... and will use some of
their 6061-T8 alloy [.120' wall]
to fabricate it. I can only get .125" wall here locally, and only in
T-6. The T-8 alloy they sell, is a full 10 ksi
stronger, and it telescopes! 1.5-1.75-2-2.25-2.5-2.75-3.0 No more
turning down the ends in a lathe, or
swedging. The telescopic fit has another huge advantage, for shipping
purposes. One size will slide
completely inside the next size, full length. You can then pack more
tubing into one box.
## another good vendor is Steve Davis...from Davis RF. This fellow goes
the extra mile, to handle odd
ball requests for one off material.
later... Jim VE7RF
More information about the TowerTalk
mailing list