[TowerTalk] Rotor questions

[Gary "Joe" Mayfield]

They are probably worth repair.  A good place to start is Norm's

http://www.rotorservice.com/

Standard disclaimer applies.

73,
Joe kk0sd

-----Original Message-----
From: towertalk-bounces at contesting.com
[mailto:towertalk-bounces at contesting.com] On Behalf Of HansLG at aol.com
Sent: Tuesday, March 09, 2010 7:09 AM
To: towertalk at contesting.com
Subject: [TowerTalk] Rotor questions

I purchased a box with some "radio junk" on a auction for a few $$ some  
time ago. It contained a bunch of CB radios but on the bottom I fount two  
antenna rotors with control boxes.
 
Today I decided to make the "keep-or-through" test of the units. One  
already had a cable between the box and the rotor which made things easier.
A  
light under the control knob and a humming noise from the rotator was the
only 
 result. Connecting the second unit like the first, 1 -> 1, 2 -> 2 etc gave 
 the same smoke test result.
 
The rotator is manufactured by CDE (Cornell Dubilier Electronics) according 
 to a label under one of the control boxes. The model number is XL-1 and 
there  are a number of rotators it can be used with such as AR-10-XL,
AR-20XL, 
 etc.
 
The rotators have bell shaped bodies and have a "TRA-4" marking underneath. 
 
Any advice? They had stickers with $100 written on them. Is it worth  
fixing? Where do I start? I remember vaguely reading something, a long time
ago, 
about a capacitor that can have dried out.
 
Hans - N2JFS
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk at contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk