[TowerTalk] pipe tap drill size
Bill Aycock
billaycock at centurytel.net
Thu Mar 11 11:21:37 PST 2010
Google is your friend--
look for "Tap Drill Size"
Tap drill-- #7 = 0.201"
Tight clearance hole is # F = 0.257"
Bill--W4BSG
----- Original Message -----
From: "r miles" <greenacres113 at charter.net>
To: "antennas" <antennas at mailman.qth.net>; "towertalk"
<towertalk at contesting.com>
Sent: Thursday, March 11, 2010 1:05 PM
Subject: [TowerTalk] pipe tap drill size
>I am putting two gusset plates to hold truss supports on my homebrew 30m
>Moxon. I'm using 1/4'' X 20 bolts. It's been 40 yr.s since I worked in a
>machine shop. Don't have the proper hole size chart for taps anymore. I
>assume the hole size to be threaded 1/4 x 20 is less than 3/16''. Anyone
>have a chart showing the proper size.TNX
> K9IL
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
>
More information about the TowerTalk
mailing list