[TowerTalk] Drill bits

[Michael Baker]

If you need to drill that many holes, get the best bit you can afford and a
sharpener and keep the bit sharp. Drill about 15 to 20 holes and resharpen.
Drill Doctor is ok and reasonably priced.

Michael Baker  K7DD
k7dd at cox.net
-----Original Message-----
From: towertalk-bounces at contesting.com
[mailto:towertalk-bounces at contesting.com] On Behalf Of Guy Molinari
Sent: Tuesday, March 23, 2010 9:12 PM
To: towertalk at contesting.com
Subject: [TowerTalk] Drill bits


Hi all,

    I don't know why this is so hard.   I'm trying to drill out some hole on
some 3/8" steel plates that I'm going to have galvanized.   I bought a
13/32" drill bit and it worked great for about 10 holes or so.   The problem
is that I have about 140 more to go.   Any recommendations on a good quality
drill bit?   

 

73,

Guy, N7ZG
 		 	   		  
_________________________________________________________________
Hotmail: Trusted email with Microsoft's powerful SPAM protection.
http://clk.atdmt.com/GBL/go/210850552/direct/01/
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk at contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk