[TowerTalk] Fwd: Source for Copperclad Steel Wire?

[hanslg at aol.com]

 How about stainless/copper MIG wire? At least it shouldn't rust. Maybe too expensive though.

Hans - N2JFS

 


 

 

-----Original Message-----
From: Roger (K8RI) <K8RI-on-TowerTalk at tm.net>
To: towertalk at contesting.com
Sent: Tue, May 18, 2010 9:41 pm
Subject: Re: [TowerTalk] Source for Copperclad Steel Wire?




On 5/18/2010 9:01 PM, Dan Zimmerman N3OX wrote:
>> How about a spool of welder wire as used in MIG welders?
>>      
>>> 73
>>>        
>>      
>
>    
>> It comes in copper clad steel?
>>
>> 73, Mike NF4L
>>      
>
> Yeah, if you consider someone who's wearing only two wraps of clear Saran
> Wrap to be "clad."
> :-)
>    
> The mild steel MIG wire I've had here comes with a copper flash on it that I
> think is juuust enough to keep it from rusting
> indoors.
>
>    
Yup.  That way it can still maintain good electrical contact through the 
rollers. Rust doesn't work very well in that application.
> I've heard of hams who tried it for antennas, etc, and it rusted through in
> short order.
>
>    
It'll even rust laying on the floor, or out unprotected on a bench.

73

Roger (K8RI)
> 73
> Dan
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
>    
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk at contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk