[TowerTalk] A couple of Inquiries
Roger (K8RI)
K8RI-on-TowerTalk at tm.net
Sat May 29 19:25:22 PDT 2010
On 5/29/2010 9:40 PM, Byron Tatum wrote:
> Hello-
> If I could impose for some information:
> 1. I bought a NOS HyGain TH3 MK4 and started assembling it today. The very first joint I tried to clamp was an element tip, where the small 1/2" tubing slips inside the slotted end of a trap. I could not tighten the hose clamp enough (with a nut driver) to get a sufficient squeeze to hold the 1/2" element tip. What is the best solution to this? I do not want to do anything I would regret later, but my thoughts were to saw another slot in the tubing, opposite the single slot that is present now. I wonder if the larger element pieces are the same way - they are thicker and look tough to squeeze.
>
Get a smaller hose clamp. There should be one of the proper size, but if
not make a visit to the local hardware store and look for SS hose clamps.
> 2. I found a balun by Cal-Av Labs (suspect is older one) model TL-3. It appears as a torroidal balun, is in a square metal case with 2 mounting holes. Does anyone have any specs on this balun?
>
>
I'd wind one using Jim Brown's tutorial.
http://audiosystemsgroup.com/publish.htm
I have a TH-5 which I think is the same or at least similar to the TH-3
and it uses a 1:1 noted for being fragile so that's what I'm doing.
73
Roger (K8RI)
> Thank you,
> Byron WA5THJ
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
>
More information about the TowerTalk
mailing list