[TowerTalk] wall plate jack for the 8 wire rotor cable
Joe Giacobello, K2XX
k2xx at swva.net
Wed Nov 3 09:43:05 PDT 2010
Kurt, I use 8-pin Cinch (Jones?) jacks and plugs between my rotors and
the wall plate (SPG panel). They allow quick disconnect in the evnt of
a lightning storm and have served me well over the years.
73, Joe
K2XX
On 11/3/2010 12:27 PM, Kurt Cathcart, KR2C wrote:
> Currently I have my Hy-gain rotor cable coming through a hole in a
> stainless steel wall plate with a grommet. I have wound up on the
> floor a bunch of excess cable before it goes to the control box. Does
> anybody make a good connector that I could mount in the wall plate so
> that I can use a shorter jumper cable from the wall to the control box?
> this way I wouldn't have to worry too much if I should re-arrange the shack.
>
> -Kurt
> KR2C
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
>
More information about the TowerTalk
mailing list