[TowerTalk] US Tower MA40 mast oops

[Kurt Cathcart, KR2C]

OK.  I pulled the bottom cap off and inside was the 3" square inner 
mast.  Attached to this was the bracket for the raising cable and also a 
4" round plate to guide it through the outer mast.  i unhooked the cable 
and pulled out the 3" square inner mast.  This was light enough for me 
to tilt up to about 75 or 80 degrees.  The 2" mast then slid down to the 
top from where it fell in from.  The problem is that at the top of the 
3" square mast is a slightly larger than 2" pipe welded to the top of 
the 3" square mast.  this pipe is only about 6" long  but I can't seem 
to get the 2" mast past the weld where the slightly larger than 2" pipe 
connects to the 3" square piece.  Any suggestions?

-Kurt
KR2C




On 10/31/2010 5:40 PM, Kurt Cathcart, KR2C wrote:
> I've been working on putting up a US Tower MA$ rotatable mast.  In my
> haste to put the mast vertical for the first time, the 2" innermost
> section wasn't tightened down and slid in to the base section.  Would
> anybody have any ideas on how to get it back out?
>
> -Kurt
> KR2C
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>