[TowerTalk] ground isntallation tips for coaxials

[Jorge Diez - CX6VM]

Hello,

 

I will do a ground installation for coaxial of the antennas, rotor lines
etc.

Near the shack, will do a hope 6 ft deep to put some bronce bars, cables,
something else I find.

Then will put two bars going up and a horizontal bar soldered to them to put
the bulkheads connectors.

I have some question:

 

-          any advice about how to solder the bars outside the ground? the
bars that will form the Π

-          I need to solder the bars that are going from the hole to the
surface or just is OK if they are in touch with all the wires,  bars I put
inside?

-          May I use concrete to cover all the bronce I put inside the hole
and over it ground, or just ground over the bronze?

 

 

Thanks,

Jorge

CX6VM/CW5W