[TowerTalk] Mast Steps
Bob K6UJ
k6uj at pacbell.net
Sun Dec 18 19:16:21 PST 2011
I made my mast steps from angle iron also. I used 1" x 1" x 1/8" galvanized angle attached to the mast with 2" heavy duty muffler clamps using 3/8 x 24 NC, SAE grade 5 u-bolts.
I sprayed the muffler clamps and ubolts with cold galvanizing spray. The steps are very solid and stable. The muffler clamps grip the mast very well and prevent any movement
by the angle when stepped on. I am anal about safety and to insure the ubolts weren't over stressed when tightened the nuts were tightened with a torque wrench
to 30 foot pounds, the recommended torque for these bolts.
73,
Bob
K6UJ
On Dec 18, 2011, at 10:21 AM, Dick Dievendorff wrote:
> Steve and I made some up with angle iron purchased at the local Ace Hardware and big U-bolts. My mast is 2-7/8 tho
>
> Dick, K6KR
>
> On Dec 18, 2011, at 7:48, "Chuck" <w5pr at swbell.net> wrote:
>
>> W9IIX no longer makes mast steps. I used to have a listing of someone who makes aluminum mast steps, but I can't find it. I need about 4 steps for a 2' mast. Does not have to be aluminum. Any ideas of where I can get them?
>>
>> Thanks!
>>
>> Chuck W5PR
>> _______________________________________________
>>
>>
>>
>> _______________________________________________
>> TowerTalk mailing list
>> TowerTalk at contesting.com
>> http://lists.contesting.com/mailman/listinfo/towertalk
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
More information about the TowerTalk
mailing list