[TowerTalk] Yaesu Rotor Bolt Pattern

[Chuck]

Thanks!

Chuck W5PR

----- Original Message ----- 
From: <MailfrmPA at aol.com>
To: <towertalk at contesting.com>
Sent: Friday, December 23, 2011 9:37 AM
Subject: Re: [TowerTalk] Yaesu Rotor Bolt Pattern


>I recently attached a Yaesu 1000 rotor to a Rohn 45 shelf and the holes
> were there and properly aligned.
>
>
> In a message dated 12/23/2011 10:22:13 A.M. Eastern Standard Time,
> w5pr at swbell.net writes:
>
> The  specs for the standard accessory shelf look to me like it is drilled
> for
> both Yaesu and Hygain rotors.  Here is the spec  sheet:
> http://www.3starinc.com/manuals/ROHN_AS25G.pdf
>
> Chuck  W5PR
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk  mailing  list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk