[TowerTalk] Crimp-on PL259 et al

K8RI on TT k8ri-on-towertalk at tm.net
Sat Feb 12 12:19:23 PST 2011


On 2/12/2011 1:17 PM, Peter Dougherty wrote:
> -----Original Message-----
>
> I've never had one pull back. It appears that possibly the wrong die was
> used not making a tight enough crimp.
> The crimp sleeve is covered so I can't tell for sure, but it looks like
> the crimp may have been too far back. It should be right against the
> connector shoulder.
>
> Photos without the heatshrink would tell much more.
>
>
> [pjd] When the crimp was made it was made flush with the barrel. It has
> pulled back within the past couple of years. I will hopefully get around to
> replacing it with a real connector this week, and when I do, I'll post a pic
> of the connector with the heat-shrink removed. This cable is the only one
> that gets any real use "day-to-day" as it's the one that gets removed when
> threatening weather approaches.
IIRC and I am going from a rather old memory, the crimp should support a 
60# dead weight with RG-8 size cable.
Normally it should take an extreme pull even at an angle to cause the 
braid to pull back.

73

Roger (K8RI)

> -----------------------------------
>
> Regards,
>
> Peter,
> W2IRT
>
>
>
>
>
>
>
>




More information about the TowerTalk mailing list