[TowerTalk] U-bolts for holes with 1 and 7/8 centers

[Mike]

Assuming you've tried the manufacturer with no luck, get a length of all-thread and 
bend your own. The big-box home centers stock it. Drilling the holes to 1/4" 
shouldn't be a problem.

73, Mike NF4L

On 6/13/2011 12:00 AM, w3qx at qsl.net wrote:
> All
>
> An otherwise very good 70cm yagi has a boom and clamp plate with
> pre-drilled quarter-inch holes:  their _centers_ are 1 and 7/8 inches
> apart.  The correct u-bolt was missing.
>
> Don't ask how how many places (including McMaster) and how long I've
> looked for a u-bolt with centers of its [ends] 1 and 7/8 inches
> apart.  I've learned there are about a half-dozen common u-bolt
> sizes, and for that dimension none come close.
>
> Help will be appreciated.  Bolt stock section 3/16 inch should be
> good; 1/4 inch would be very tight.
>
> Best regards,
> William W3QX
>
>
>
>
>    -30-
>
>
>
>
>
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>