[TowerTalk] Rohn 45 Bearing Plate

[Mark Robinson]

The Rohn 45 bearing plate that Array Solutions sells can be inserted at the
junction between tower sections and moved into position vertically. It can
then be tapped/hammered horizontal using a rubber mallet anywhere within a
section..  I am using such a method on my Rohn 45 tower and inserted the
extra bearing plate and rotor plate while working at the top of the tower

I hope this answers your question.


Mark N1UK



----- Original Message ----- 
From: "rfman45" <rfman45 at hotmail.com>
To: <towertalk at contesting.com>
Sent: Tuesday, 03 May, 2011 4:35 PM
Subject: [TowerTalk] Rohn 45 Bearing Plate


>
> I am using Rohn 45 and want to put a second thrust bearing between the 
> rotator and mast. The bearing plate p/n BPL45G can only be mounted at the 
> top. Is there any way of putting a second bearing plate between the 
> rotator and the the top baring plate?
>
> Thanks in advance!
>                                     Mike  W2LO
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk