[TowerTalk] Copper Pipe Ground Rods - Driving them in - How ?

[Adam Shirley WJ4X]

This works.

http://www.eham.net/articles/23198

I soldered male adapters onto my pipe, and used a hose bib adapter.

73!
 -Adam



On 5/25/2011 8:28 AM, Dan Bookwalter wrote:
> Ok , I have most of my ground system planned out , my plan is to use copper pipe 
> (type "L") and silver solder flashing to them from the tower etc...  my issue is 
> how in the world do you guys drive copper pipe into the ground , I have access 
> to a 1/2" hammer drill , but , the pipe is too large for that , I am going to 
> check into a ground rod bit for it , but , I am still not so sure if that will 
> work.
> 
> Suggestions ??
> 
> Dan N8DCJ
> 
> _______________________________________________
> 
> 
> 
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>