[TowerTalk] Copper ground rod driver

john at kk9a.com john at kk9a.com
Wed May 25 18:02:43 PDT 2011


You're lucky.  I got no where trying to install ground rods with a sledge 
hammer in my shale and clay soil.  I used a large electric jack hammer to 
install them and even with this machine I was only partially successful.

John KK9A



To: <jtml at vla.com>, <towertalk at contesting.com>
Subject: Re: [TowerTalk] Copper ground rod driver
From: "Mark Robinson" <markrob at mindspring.com>
Date: Wed, 25 May 2011 19:26:54 -0400
List-post: <towertalk at contesting.com">mailto:towertalk at contesting.com>

Yes I tried that fence post tool but I preferred to use a lump hammer and
then switch to a sledge when the going got tougher. I was able to get 10
foot ground rods in below ground level. Some were easier than others

The Tractor Supply place had them.

Mark N1UK 



More information about the TowerTalk mailing list