[TowerTalk] Thrust bearings

[jpk5lad at cox.net]

The hole was cut for a 2" mast but Rohn also sold a cast 
metal bushing to stick in that hole, one for 1 1/2" masts  
and one for 1 1/4" mast.  Not too fancy.

Jim - K5LAD



On 10 Oct 2011 at 9:23, jcjacobsen at q.com wrote:

> I seem to remember that someone (Rohn?) used to market an "Amateur
> Bearing" that was nothing more than a good sized chunk of Oak with a
> hole drilled in it. Just bolt it to the top plate and go for it. 
> 
> K9WN Jake 
> _______________________________________________
> 
> 
> 
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk


===========================================
=====
Growing old is like being increasingly penalized 
for a crime you haven't committed.
-- Anthony Powell
-----------------
Visit my webpages at:
      http://www.hayseed.net/~jpk5lad/
===========================================
=====