[TowerTalk] Wilson 40ft tubular towers

[Mike]

If I remember the only difference is that the top section on the US towers
model is square and the Wilson is tubular.

Weld some angle to hold the rotator below the hinge and your good to go.

-Mike, K6BR

-----Original Message-----
From: towertalk-bounces at contesting.com
[mailto:towertalk-bounces at contesting.com] On Behalf Of Greg
Sent: Wednesday, October 19, 2011 3:38 PM
To: towertalk at contesting.com
Subject: [TowerTalk] Wilson 40ft tubular towers

I am looking at purchasing a used Wilson tubular 40ft tower locally that
includes the free standing rasing fixture.  This is similar if not identical
to the US Towers MAB.  The MAB and MARB look identical except the latter has
a mounting bracket for the rotor below the hinge point and a thrust bearing
on a plate where the hinge goes.

Anyone know of any negatives if I fashion a bracket for the rotor my self
and build and adapter to pin to the mast section that gets hinged?
Basically converting it to an MARB type base.

I don't plan to put much on this.  Maybe support one or two wire antennas
and two 6M5X yagis.  Or at most a couple small satellite antennas with one
6M5X above them.

Thanks
Greg
AB7R
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk at contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
-----
No virus found in this message.
Checked by AVG - www.avg.com
Version: 2012.0.1831 / Virus Database: 2092/4560 - Release Date: 10/18/11